On 12/02/2015 07:43 PM, Kevin Hilman wrote:
On Wed, Dec 2, 2015 at 4:35 PM, Jorge Ramirez-Ortiz jorge.ramirez-ortiz@linaro.org wrote:
On 12/02/2015 06:57 PM, Kevin Hilman wrote:
debug EMMC boot: print init OK debug EMMC boot: send RST_N . debug EMMC boot: start eMMC boot...... load fastboot1!
actually this doesnt look like a UEFI boot. what bootloader are you programming?
I'm assuming it's UEFI: I followed the "Board Recovery" instructions verbatim: https://github.com/96boards/documentation/wiki/HiKeyGettingStarted#section-4
Kevin
what partition table did you use (4G)?
this is what I see during early boot
NOTICE: Booting Trusted Firmware NOTICE: BL1: v1.1(release):e9b4909 NOTICE: BL1: Built : 10:50:16, Nov 28 2015 NOTICE: syspll frequency:1190494208Hz NOTICE: succeed to init lpddr3 rank0 dram phy INFO: lpddr3_freq_init, set ddrc 533mhz INFO: init ddr3 rank0 INFO: ddr3 rank1 init pass INFO: lpddr3_freq_init, set ddrc 800mhz INFO: init ddr3 rank0 INFO: ddr3 rank1 init pass INFO: Elpida DDR
... ...
seems to me UEFI wasnt updated