Please don't top-post.
Op 11 mrt. 2015, om 10:35 heeft David Rusling david.rusling@linaro.org het volgende geschreven:
I followed the instructions in the wiki, together with the pre-built binaries and I get:
debug EMMC boot: print init OK debug EMMC boot: send RST_N . debug EMMC boot: start eMMC boot...... load fastboot1!
Switch to aarch64 mode. CPU0 executes at 0xf9801000! NOTICE: Booting Trusted Firmware NOTICE: BL1: v1.1(release):9a97502 NOTICE: BL1: Built : 08:13:36, Mar 10 2015 NOTICE: succeed to init lpddr3 rank0 dram phy INFO: lpddr3_freq_init, set ddrc 533mhz INFO: init ddr3 rank0 in 533MHz INFO: ddr3 rank1 init pass in 533MHz INFO: Elpida DDR ERROR: Failed to load BL2 firmware. PANIC at PC : 0x00000000f9805780
I had the same problem, it went away by repeating all the steps. I do have the problem where I have to power cycle twice to start UEFI from time to time.
-- Koen Kooi Builds and Baselines | Release Manager Linaro.org | Open source software for ARM SoCs