On 21/01/16 19:31, Geoff Levand wrote:
Hi,
On Thu, 2016-01-21 at 09:55 +0100, Jerome Forissier wrote:
$ md5sum linux/.config dc59a664c9e9f4fb9078cf9ccf127271 linux/.config
I get the same md5sum.
Here is what I see:
EFI stub: Booting Linux Kernel... EFI stub: Using DTB from configuration table EFI stub: Exiting boot services and installing virtual address map... dmi: Firmware registration failed.
There's been a lot of confusion on this board about which serial port logs for different components emerge from.
This was caused by a migration from using the (unpopulated) 4 pin UART header to LS-UART1 on the low speed mezzanine connector. Over time the firmware, bootloader, vendor kernel and upstream kernel have all switched their defaults to LS-UART1.
In fact I believe v4.4 is the first upstream release to support, and have DTS defaults pointed at, LS-UART1 (ttyAMA3). Would this have affected you?
Daniel.