Trying to update firmware on a hikey that was previously running u-boot just fine, I followed the "Board Recovery" section of the Getting Started page[1], but end up with the init sequence getting stuck in TEE-CORE init (console log below[2])
Any ideas what's going wrong?
I'm trying to update the firmware so I get serial output on the UART board. I'm currently only using the UART pins on the main board.
Kevin
[1] https://github.com/96boards/documentation/wiki/HiKeyGettingStarted#section-4
[2] debug EMMC boot: print init OK debug EMMC boot: send RST_N . debug EMMC boot: start eMMC boot...... load fastboot1!
Switch to aarch64 mode. CPU0 executes at 0xf9801000! INF TEE-CORE:init_primary_helper:322: Initializing (2f04385 #2 Sat Nov 28 10:50:14 UTC 2015 aarch64) INF TEE-CORE:init_teecore:81: teecore inits done